Enter Firing Time; Save Program; Start Program; Copy Program - DENTSPLY MULTIMAT C Mode D'emploi

6.9 Enter firing time

Press the cursor button " ". The cursor selects the firing time.
Use the numeric keypad 0 – 9 to enter e.g. 2.0 (fixed decimal
point).
01000 0500 080
0000 06 0 03 00
Note:
The firing time must be at least 0.3 min longer than the vacuum
time.

6.10 Save program

Save your program by pressing the button "S" and subse-
quently entering the program number, e.g. 01, with the numeric
keypad.

6.11 Start program

Press the button "start/stop". The green LED lights up and the
total firing time is displayed in the in the lower left display.
01000 0500 080
0017 06 0 03 00
During firing, the following functions are available with the
appropriate buttons:
a. Move lift (View function)
b. Abort program
c. Abort vacuum or View function
d. Start editing (change parameters)
e. Show all theoretical parameter values
f. Delete errors

6.12 Copy program

Copy your program by pressing the button "S" and subse-
quently entering the desired program number with the numeric
keypad.

6.13 Special program

A saved program can be changed to a single special program by
changing individual data and starting the program without press-
ing the button S.
34
0 0940 0c0020
50 0 01,0 02,0 0
0 0940 0c0020
50 0 01,0 02,0 0
Lift buttons „
Button start/stop
Button "C"
Button "E"
Button "M"
Button "C"

7 Specialised functions

7.1 Standby

Standby can be preset in the sub-menu "Configuration".
In addition to the existing vacuum, this function allows
maintaining a temperature of 120 °C in the firing chamber in
"Off" state.
This function is also useful to keep moisture out of the firing
chamber.
Display:
120
(theoretical °C)
7.2 Vacuum as special function
Vacuum can be preset in the sub-menu "Configuration". This
function allows maintaining a vacuum in the firing chamber in
"Off" state.
This function is used to keep moisture out of the firing chamber.
Display:
8
(theoretical value 800 hPa)
"

7.3 Rapid cooling

If quick cooling is not preset in the configuration, it can be
switched on manually after the program is completed and the
firing chamber opened by pressing the lift button "B". In this
case, the actual temperature must be greater than the theoreti-
cal preheating temperature. Press the button "C" to abort the
quick cooling.

7.4 View function

During firing without vacuum it is permissible to move the firing
chamber downwards with the lift button "B" and stop it with the
lift button "L", in order inspect the workpiece. The firing time is
stopped and the cursor appears on the firing temperature.
Using the cursor buttons " ", and " ", the firing temperature
can now be decreased or increased. Press the lift button "L" to
close the firing chamber again. The program continues. After the
temperature has been set, post-firing is possible for up to three
minutes. The post-firing time counts up from zero. Post-firing
can be aborted at any time with the "start/stop" button.
Standby
OFF
(actual value 800 hPa)
(manual)
(soldering)
120
(actual °C)
8