Practical Application: Introduction; Display - DENTSPLY MULTIMAT C Mode D'emploi

Rapid cooling
Preheating
Program temperature -
number theoretical
Total Preheating
firing time time
Error Drying
messages time
Start test program
Press button "start/stop".
The start control light illuminates and a blinking arrow, left of the
drying time, indicates that the preheating time has not been
reached.
After reaching the preheating time, the approximate total firing
time/remaining firing time is displayed in the lower left corner and
the program sequence starts with the drying phase.
A flashing of the data display of the program step indicates that
this step is being processed and the appropriate time is counted
down to zero.
At the end of every program step the relevant data display goes
out. The remaining total firing time/remaining firing time is newly
approximated after each program step has been completed.
Once the set vacuum level is reached, the temperature increase
starts.
When the test program is finished, the lift moves down and a
acoustic signal sounds.
30
Heating rate
temperature
Firing
temperature -
theoretical
Vacuum Cooling
time
Vacuum
level Firing time
Actual

5 Practical application: introduction

°C
5.1 Limit values of the firing temperature
Parameter
Preheating temperature -
theoretical
Heating rate
Firing temperature - theoretical
Firing temperature - actual
Drying time
stages
Preheating time
Vacuum level
Vacuum time
Firing time
View
Standby temperature
Standby vacuum
Cooling
Values outside these limits are not accepted when saving,
starting and altering a program during firing. A signal will sound
to inform the user.

5.2 Display

Illuminated display for simultaneous display of all firing para-
meters.
Key to the symbols and the appropriate firing temperature:
Rapid cooling
Program
number
Total
firing time
Error
messages
Lower limit
100 °C
1 °C/min.
300 °C
0 °C
0 min.
0 min.
1 hPa
0.00 min.
0.00 min.
00.1 Min
120 °C fixed
800 hPa fixed
3 stages
(1, 2 and 3)
Heating rate
Preheating
temperature - temperature -
theoretical
Preheating
time
Drying Vacuum
time level
Upper limit
1200 °C
120 °C/min.
or max.
1200 °C
1250 °C
25 min.
25 min.
99 hPa
99.5 min.
99.5 min.
3.0 min.
Actual
temperature
Firing
°C
theoretical
Vacuum Cooling
time stages
Firing time