Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.6.3
RS485 Setup
Luxsar
protocol. The RS-485 parameters in
the same parameters as the protocol for RS-422 setup of the dome.
Users are allowed to change the RS-485 settings of the
VDR840C/VDR440C. Select <System Setup> in Main menu, then select
<RS485 Setup> from the System Setup menu and press ENTER. The following
menu is displayed.
1 Unit ID
2 Baud Rate
3 Bits
4 Stop
5 Parity
The ID number must match the ID address set by the dome. The Unit ID is in the
range of 1 to 255. The default ID is 224. Note that no two devices on the same
bus should be given the same ID address, or a conflict may occur.
The default
Data Bits, 1 Stop Bit and No Parity.
NOTE: The settings become effective after saving the changes and
exiting from the menu.
VDR840C-440C_En_V1.2
VDR840C/VDR440C controls the domes via RS-485 communication
VDR840C/VDR440C RS-485 settings are 9600 Baud, 8
Luxsar
VDR840C/VDR440C must be set to
Luxsar
RS485 Setup
33
User's Manual
Luxsar
224
9600
8
1
None
Publicité
Table des Matières
