Position The Unit; Selecting Video Format; Connecting Devices To The Unit - LUXSAR VDR840C Manuel D'installation

2.1

Position the Unit

Position / mount the
to power off the unit before making any connections. The placed location should
avoid hindering or blocking the unit from airflow. Enough airflow is needed to
protect the unit from overheating. The maximum allowable temperature of
operating environment is 40°C.
The unit utilizes heat-conducting techniques to transfer internal heat to the case,
especially to the bottom side of the unit.
2.2

Selecting Video Format

The
Luxsar
PAL video formats. The switch is positioned on the rear panel.
2.3

Connecting Devices to the Unit

This section lists some important notices that should be read before making
any connections to the
powered up.
Connecting Required Devices
Before power up the unit, you should connect cameras and a main monitor to
the unit for basic operation. If needed, connect a call monitor for displaying full
screen video of all installed cameras in sequence.
VDR840C-440C_En_V1.2
VDR840C/VDR440C in a proper place and be sure
Luxsar
NOTE: Be sure not to remove the rubber feet, and always leave a
space for air ventilation on the unit's bottom side.
VDR840C/VDR440C is designed to operate under either NTSC or
Luxsar
NOTE: Connect short-term devices, such as USB ThumbDrive
CD-ROM, USB Hard Disk Drive, etc., only after the unit is successfully
VDR840C/VDR440C.
9
User's Manual
®
, USB