Sauder 409128 Manuel D'instructions page 9

Step 4 Step
Separate the EXTENSION SLIDES (BB) from the
å
EXTENSION RAILS (AA) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (AA) to a LOWER END (C
å
and D). Use four GOLD 5/16" FLAT HEAD SCREWS (YY).
Repeat this step for the remaining LOWER ENDS (C and D).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Finished edge
www.sauder.com/services
BB
AA
D
AA
Finished edge
C
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
409128
Remember:
Righty tighty.
Lefty loosey.
Open end
AA
YY
Page 9