Wireless 7-In-1 Sensor Alignment; Wireless Hygro-Thermo Sensor; Install Wireless Thermo-Hygrometer Sensor - Bresser 7003500 Mode D'emploi

3.1.4

WIRELESS 7-IN-1 SENSOR ALIGNMENT

Install the wireless 7-IN-1 sensor in an open location with
Install the wireless 7-IN-1 sensor in an open
no obstructions above and around the sensor for accurate
location with no obstructions above and around the
rain and wind measurement. Install the sensor with the
sensor for accurate rain and wind measurement.
smaller end facing the North to properly orient the wind
Install the sensor with the smaller end facing the
direction vane. Secure the mounting stand and bracket
North to properly orient the wind direction vane.
(included) to a post or pole, and allow minimum 1.5m off
Secure the mounting stand and bracket (included)
the ground.
to a post or pole, and allow minimum 1.5m off the
ground.
Add rubber
pad before
Add rubber
mounting on
pad before
pole or post
mounting on
pole or post

3.2 WIRELESS HYGRO-THERMO SENSOR

1. Transmission status LED
2. Wall mounting holder
3. Channel slide switch
4. Reset
5. Battery compartment
3.2.1

INSTALL WIRELESS THERMO-HYGROMETER SENSOR

1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the sensor (e.g.
Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and close the
battery door according to the polarity information marked on the battery
compartment.
4. The sensor is in synchronization mode, and can be registered to the console
within the next few minutes. The transmission status LED will begin to flash
every 1 minute.
1
60
Fixed pole
Fixed pole
package not
(not included)
included
2
3
4
5
Point to
Point to
NORTH
NORTH
1.5 meter
1.5 meter
off the
off the
ground
ground