Technical Data - Roco 10798 Mode D'emploi

Connection
Connect the two yellow wires of the connector track (or similarly the two wires of your power feed) onto
the yellow clips on the controller (Fig. 1). To do so, simply press the yellow clips downwards and insert
the unisolated ends of the wires sideways into the opening which can be clearly seen (Fig. 2). After re-
leasing the connecting clips, the wiring is fastened to the track layout. Connect the mains transformer to
the controller using the cable from the transformer, and then plug the mains plug into the mains supply
(Fig. 3) – and now the model railway layout is ready for use.
The white and black terminals are designed for the operation of
• points, relays or semaphore signals via corresponding push-button control panels
• ... and/or of incandescent lamps or LED lighting devices,
as well as of light signals, sensibly controlled via switches (ON/OFF or ON/ON). If no function of LED's
(=lighting diodes) can be observed on control panels with feedback or light signals, the connecting
cables used must be exchanged in the terminals white and black!
Function principles of the controller and mains transformer
The controller set is best suited for use by beginners and for operation with just one train. The mains
trans-former unit reduces the mains supply of 230 volts into a safe voltage of 14 volts, necessary for
the operation. The two yellow clips on the rear of the controller then deliver the controllable power for
operation to the tracks. By turning the control knob to the left, the loco will run to the left. Returning
the control knob to the centre, the loco will bring to a halt. By turning the control knob to the right, the
loco will run to the right. If the running direction of your loco is reversed, then simply swop over the two
yellow wires on the controller. The power necessary to operate electrical accessories (i.e. point motors,
lighting, signals etc.) comes from the black and white clips.
Automatic overload protection
In the event of overload, or likewise a short circuit, the controller switches itself off. In this case, please
set the control knob to the centre setting and remove the cause of the short circuit, or whatever caused
the overload. After a short interval to cool down, the equipment can be used again.

Technical data

(valid exclusively for controller in conjunction with mains transformer)
• Control area of the power output: 0 - 14 volts, continuous power up to 600 mA.
• Separate DC power output 14 volts for lighting and electrically operated accessories.
• Maximum power rating: 850 mA (12 VA).
• Measurements: controller appr. 125 x 70 x 43 mm, mains transformer appr. 87 x 60 x 45 mm.Aver-
tissements, consignee de sécurité et d'utilisation
8010798920 XII_2022.indd 5 8010798920 XII_2022.indd 5
GB
5
14.12.2022 10:20:26 14.12.2022 10:20:26