Removing The Cover - Chicco Relax&Play Mode D'emploi

• The batteries have been inserted correctly
• The console contact points are not corroded or damaged
• Baby's weight is appropriate
• Baby isn't leaning too far forward
WARNING: The swing comes with protective equipment that stops
the rocking after 30 minutes of use. Should the rocking stop, wait a
few minutes before starting it up again.
WARNING: Switch off the product when it is not in use by pressing
the ON/OFF button.
FOLDING AND TRANSPORT
13. To fold the swing after use, fold the seat as shown in figure 13
and hold it in place with the strap and button found on the seat
(Fig.13A).
14. Press locking buttons A1 and B1 to draw in the legs as shown
in figure 14.
WARNING: Never use the toybar to transport the swing.

REMOVING THE COVER

15. To remove the cover of the swing, fold the frame of seat D (Fig. 15).
16. Grasp the fabric and pull it gently towards you (Fig. 16).
17. Release shoulder straps D4 from the adjusters on the back of the
backrest (Fig. 17).
18. Remove the fabric completely from the seat frame (Fig.18).
19. To put the fabric back on after washing, following the instruc-
tions above in reverse order, taking care to insert the shoulder
straps correctly inside the designated adjusters (Fig. 19).
WARRANTY
The product is guaranteed against any conformity defect in normal
conditions of use as provided for by the instructions. The warranty
shall not therefore apply in the case of damage caused by improper
use, wear or accidental events. For the duration of the warranty on
conformity defects please refer to the specific provisions of national
laws applicable in the country of purchase.
THIS PRODUCT COMPLIES WITH THE DIRECTIVE
2012/19/EU.
The crossed bin symbol on the appliance indicates that
the product, at the end of its life, must be disposed of
separately from domestic waste, either by taking it to a
separate waste disposal site for electric and electronic
appliances or by returning it to your dealer when you buy another
similar appliance. The user is responsible for taking the appliance
to a special waste disposal site at the end of its life. If the unwanted
appliance is collected correctly as separate waste, it can be recycled,
treated and disposed of ecologically; this avoids a negative impact
on both the environment and health, and contributes towards the
recycling of the product's materials.For further information regard-
ing the waste disposal services available, contact your local waste
disposal agency or the shop where you bought the appliance.
Made in China
11