Adjusting The Backrest - Chicco Comfy Wave Mode D'emploi

the buckles on the crotch strap (Fig. 13)
8. Adjust the length of the shoulder straps "G2" by moving the
strap through the adjustment ring (Fig. 14)
9. Adjust the length of the crotch strap "G1" by tugging on the
ends of the straps "G4" (Fig. 15)
WARNING: When using the product, always fasten the 5-point
safety harnesses and check that they fit snugly against the
child's body.

ADJUSTING THE BACKREST

10. To adjust the inclination of the backrest from more inclined
to less inclined, press the button "D1" and have the arch
"D" run forwards or backwards until the desired inclination
is reached and a click is heard confirming that the arch has
locked in place (Fig.16). The reclined cradle can be reclined
into 3 positions. This operation may also be carried out with
the child sitting in the baby cradle. In this case it can be more
difficult.
WARNING: Always check that the backrest is properly locked
before use.
USING THE TOYBAR
11. The toybar can be rotated to the right or left (Fig. 17). To re-
move it press the button "E3" and rotate externally (Fig. 18).
USE WITH ROCKING MOVEMENT
The reclined cradle is equipped with a motorised mechanism
(8 different movements) and sound system (15 different tunes
and sounds of nature). Sound and movement can be activated
separately.
12. To activate the motorised function the power cable "I"
must be plugged into the mains and the jack connector
"I1" plugged into the jack socket "A2" (Fig. 19).
13. To activate the electronic panel "B" press the power button
"B1".
14. To activate movement, press the increase speed button
"B6". The screen will briefly display the speed setting se-
lected. Press buttons "B5" or "B6" to reduce or increase the
speed. At number 0 the reclined cradle is still, while number
5 indicates maximum speed.
15. To change the movement press button "B7" and choose
from one of the 8 movement options. This operation can
only be carried out while the reclined cradle is functioning.
16. To activate the tunes press the "B3" button once. The 15
tunes will play automatically one after the other.
To switch to a different tune press the same button until the
desired tune is found.
If you do not wish to play through the automatic list of
tunes, long press button "B4" to lock the sound on a spe-
cific tune.
To adjust the volume long press button "B3".
17. To deactivate music press button "B4" once.
18. The movement of the reclined cradle continues for 30 min-
utes, after which it switches off. Still, a 10, 20, or 30-minute
timer can be set by pressing button "B2". Pressing once
sets the timer to 10 minutes, twice to 20 minutes, and three
times to 30 minutes.
REMOVING THE COVER AND WASHING
The fabric of the reclined cradle can be removed and washed.
Follow these steps to complete the operation:
- Remove the toybar "H" as described in point 11.
- Release the seat from the base by pressing button "D2" and
pulling up on the seat (Fig. 20).
- Release the inclination adjustment arch "D" by first pressing
on the pin located on the head area plastic insert "E1" and
pulling up on that part of the arch (Fig.21) then pressing on
the pin located on the foot area plastic insert "E2" and pulling
30° C
30° C
30° C
30° C
up on that part of the arch (Fig. 22).
- Release the buckle "F1" found on the rear of the seat (Fig. 23).
- Remove the fabric from the seat frame starting from the foot
area and then removing it from the head area plastic insert
"E1" (Fig. 24-25).
Please refer to the care label for instructions on washing the
product:
Machine washable at 30°C
30° C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Do not twist or wring
line drying
Check that the fabric and stitching are in good condition each
time you wash it.
To reposition the fabric on the seat frame, carry out the steps
described above in reverse order.
Periodically wipe the plastic parts clean with a soft damp cloth.
After possible contact with water, dry the metal parts in order
to avoid the formation of rust. Do not use solvents or abrasive
products.
• This product requires periodical maintenance.
• Cleaning and maintenance operations must only be carried
out by an adult.
THIS PRODUCT COMPLIES WITH THE DIRECTIVE
2012/19/EU.
The crossed bin symbol on the appliance indicates that
the product, at the end of its life, must be disposed of
separately from domestic waste, either by taking it to a sepa-
rate waste disposal site for electric and electronic appliances
or by returning it to your dealer when you buy another similar
appliance. The user is responsible for taking the appliance to a
special waste disposal site at the end of its life. If the unwant-
ed appliance is collected correctly as separate waste, it can be
recycled, treated and disposed of ecologically; this avoids a
negative impact on both the environment and health, and con-
tributes towards the recycling of the product's materials. Illegal
disposal of the product by the user will result in administrative
sanctions provided by law. For further information regarding
the waste disposal services available, contact your local waste
disposal agency or the shop where you bought the appliance.
WARRANTY
The product is guaranteed against any lack of conformity under
normal use as specified in the instructions. The warranty does
not, therefore, apply to damage caused by improper use, wear
or accidents. For the duration of the warranty on conformity
defects, please refer to the specific provisions of national laws
applicable in the country of purchase.
Made in China
12