FAAC Night & Day Basic Mode D'emploi page 5

5
INSTALLING the MOTOR HOUSING + TRANSMISSION HOUSING
1 - Pre-assemble the two housings: the transmission rod enters the
2 - Take the motor housing + transmission housing group under
the lintel and screw (without tightening) the two 8x80
woodscrews and the 6x50 woodscrews.
- 1 -
POSITIONING the ARMS
7
Insert the following in sequence: Right arm (=) + Washer (#) + Screw.
Tighten but DO NOT LOCK. Repeat this operation on the left arm.
(#): Be careful over the direction of the washer:
the sunk side must point upward.
(=): Be careful over the direction of the arms:
the roller must face upward.
9
FIXING THE SLIDING TRACKS
Position the track on the roller and take it to the shutter.
Centre the track on the reference marks and check the
level. Insert the fittings and screw the 4 screws.
11
INSTALLING the CENTRAL COVER
Locate the central cover with respect to the length of the
lintel and push it upward until it clicks.
FAAC S.p.A. Via Benini, 1 Zola Predosa (BO) - ITALIA Tel.: 051/61724 www.faacgroup.com
cylindrical sleeve.
- 2 -
ALIGNING and TIGHTENING the MOTOR HOUSING +
6
TRANSMISSION HOUSING
Using a ruler, make sure that the two housings are well aligned.
Check level in both directions and adjust if necessary.
Tighten the 3 woodscrews.
8
FINDING the CORRECT ARM TRAVEL
Find the axis of the arm's roller:
-1- shutter open and -2- shutter closed.
- 1 -
- 2 -
10
Open the shutters to the full. Tighten and LOCK the arm
screws. Place the cap on the screw head.
12 ELECTRICAL CONNECTION of the CONTROL BOX
LOCKING the ARMS