FAAC Night & Day Basic Mode D'emploi page 4

11.3 Sliding track fitting 4.2
12.3 Screw 5x40
11.4 Sliding track fitting
12.4 Screw 5x40
10.2 Sliding track
6.D Right arm
7.2 Washer
8.2 Screw M12x60
9.2 Cap
CHECKING THE SHUTTERS
1
First of all, check if the travel of the shutters is correct. If nec-
essary, loosen and lubricate the hinges. Remove the shutter
stops. Cut the manoeuvring rod at 60 mm from the top end
PREPARING the HOUSINGS
3
1 - Insert the transmission rod in the transmission housing so
that it reaches the END of the housing.
2 - Cut and deburr the transmission
PANEL WIDTH
- 2 -
N.B.: For windows with a width of less than 1000 mm, cut the profile
of the transmission unit to the required size.
FAAC S.p.A. Via Benini, 1 Zola Predosa (BO) - ITALIA Tel.: 051/61724 www.faacgroup.com
NIGHT & DAY BASIC
Automated system for shutters
1 Motor + transmission housing
Woodscrew
8x80
of the shutter.
rod at point L.
- 1 -
2 Transmission rod
5 Woodscrew
6x50
13 Central cover
14 Control box
15 Instructions for control box
16 CE Certificate
2
Under the lintel, draw a line parallel to the wall and aligned
with the rabbet: this is the closing limit of the shutters. Remove
4
1 - Take the motor housing + transmission housing group under the lintel.
Outer face (chamfered) against the reference line.
2 - Mark the references through the 3 holes of the motor housing
3 - Select the appropriate expansion plug and drill bit then drill
4 - Position the expansion plugs in the holes (*)
(*) Selection of the expansion plugs depends on the nature
of support and, therefore, this is your entire responsibility.
3 Transmission housing
4.1 Woodscrew 8x80
11.1 Sliding track fitting
12.1 Screw 5x40
10.1 Sliding track
6.G Left arm
7.1 Washer
8.1 Screw M12x60
9.1 Cap
FINDING the MOUNTING LINE
the rabbet.
MARKING-OUT the SECURING HOLES
+ transmission housing group.
the holes.
11.2 Sliding track
fitting
12.2 Screw 5x40