Battery Type Setting; Before Machine Start-Up; Brush Or Pad-Holder Installation - Nilfisk Advance SC401 Instructions D'utilisation

ENGLISH

Battery type setting

Set the electronic board of the machine according to the type of
batteries installed (WET or GEL) as shown below:
10. (If equipped) Turn the ignition key (41) to "I".
Press the main push-button (42) to turn on the machine,
then detect the current setting by checking in the very first
seconds the battery symbol LED flashing (see Figure 2):
11. If the setting is to be changed, press the push-button (44)
for 3 seconds.
12. Within 3 seconds, shortly press the push-button (44) to
select a new setting.
13. Wait 3 seconds for the battery symbol to display the battery
charge status.
WARNING!
In the machines equipped with on-board battery
charger, the installed batteries (WET or GEL/
AGM) may require a specific charging algorithm:
always contact a Advance Service Center to set
the charging algorithm most appropriate for the
installed batteries.
Battery Charging
14. Fully charge the batteries (see the procedure in
Maintenance chapter).

BEFORE MACHINE START-UP

Brush or pad-holder installation

According to the kind of cleaning to be performed, the machine
can be equipped either with the brush (A, Fig. 2) or the pad-
holder (B) with pad (C) together with the appropriate deck.
1. Place the brush (A) or the pad-holder (B) under the brush
deck (26).
2. (If equipped) Turn the ignition key (41) to "I".
Press the main push-button (42) to start the machine.
3. Press the main push-button (42, LED on) again.
4. Lower the brush deck by pressing the pedal (10-B).
5. To activate the brush engagement function, press the
push-buttons (44) and (42) simultaneously for one second.
Brush or pad-holder removal
6. Press the main push-button (42, LED off).
7. Lift the brush deck by pressing the pedal (10-A).
8. To activate the brush disengagement function, press the
push-buttons (44) and (42) simultaneously for one second,
then wait for the brush to fall on the floor.
NOTE
When the brush engagement/disengagement function
is activated, the push-button LED (42) flashes.
12
INSTRUCTIONS FOR USE
SC401 - 9100002290
GEL/AGM
WET
Figure 2
A
B
C
Figure 2
P100949
P100950
09/2017