Warnings And Instructions - Stihl AL 301 Notice D'emploi

English
5.3

Warnings and Instructions

WARNING
￭ To reduce the risk of fire, electric shock and other
personal injury or property damage:
– Before using the charger, read this instruction
manual and all instructions and warnings on the
charger, battery and product using the battery.
– Use the STIHL AL 301 to charge only genuine
STIHL AK, AP or AR series batteries. Other batteries
may burst, catch fire or explode, resulting in
personal injury and property damage.
– For indoor use only.
– Keep the charger dry. Protect it from
rain, water, liquids and damp conditions.
Never insert a wet battery or use a wet
charger.
– Do not handle the charger, including power supply
cord and plug, with wet hands.
– Never use a damaged charger.
– Never charge malfunctioning, damaged, cracked,
leaking or deformed batteries.
– When storing the battery, maintain a charge of 40%
to 60% for STIHL AP series batteries and a charge
of 30 % to 45 % for STIHL AR series batteries (2
green LEDs).
– If storing the battery in the charger, disconnect the
charger from the outlet.
– Operate the charger only indoors, in dry rooms and
within an ambient temperature range of 41 °F to
104 °F (5 °C to 40 °C).
– Keep the charger out of the reach of children.
– Always plug the charger into a properly installed
electrical outlet / power source matching the voltage
and electrical frequency stated on the charger.
4
5 IMPORTANT SAFETY INSTRUCTIONS
– If too many devices are connected to a power strip,
electrical components can be overloaded during
charging, leading to overheating and fire. If using a
power strip, never exceed its total capacity.
– Do not operate a charger that has received a sharp
or heavy blow, has been dropped or is otherwise
damaged in any way.
– Do not attempt to repair, open or disassemble the
charger. There are no user-serviceable parts inside.
￭ To reduce the risk of electric shock or fire from a short
circuit:
– Make sure the battery and charger are completely
dry before starting the charging process.
– Never bridge the contacts of the charger with wires
or other metallic objects.
– Do not insert any objects into the charger's cooling
slots.
￭ The charger heats up during the charging process. To
reduce the risk of fire:
– Do not operate on a combustible surface (e.g.,
paper, cardboard, textiles) or in a combustible
environment.
– Allow the charger to cool down normally. Do not
cover it.
￭ Chargers can produce sparks which may ignite
combustible gases, liquids, vapors, dusts or other
combustible materials. To reduce the risk of fire and
explosion:
– Do not operate in a location where combustible
gases, liquids, vapors, dusts or other combustible
materials are present.
￭ Using a damaged power supply cord or plug may result in
fire, electric shock and other personal injury or property
damage. To reduce these risks:
0458-010-8221-A