Charging The Battery; Setting Up The Charger - Stihl AL 301 Notice D'emploi

English
￭ To reduce the risk of electric shock:
– Unplug the charger from the electrical outlet before
inspecting or cleaning the charger.
– Regularly check the electrical contacts of the
charger and ensure that the insulation of the power
cord and plug are in good condition and show no
signs of aging (brittleness), wear or damage.
– Have a damaged power supply cord replaced by an
authorized STIHL servicing dealer.
￭ Improper storage can result in unauthorized use, damage
to the charger, and an increased risk of fire, electric shock
and other personal injury or property damage.
– If storing the battery in the charger, disconnect the
charger from the outlet.
– Store the charger indoors in a dry and secure
location.
– Keep it out of the reach of children or other
unauthorized persons.
SAVE THESE
INSTRUCTIONS

7 CHARGING THE BATTERY

7.1

Setting up the Charger

WARNING
Read and follow the safety precautions on the battery and
charger and the warnings and instructions in this manual,
@ 5. To reduce the risk of short circuit, which could lead to
electric shock, fire and explosion, make sure the charger
and its components are dry and not damaged; operate the
charger indoors at an appropriate ambient temperature,
@ 5.
6
WARNING
A typical household electrical circuit is between 15 and
20 amps. A single STIHL AL 301 draws approximately
4.4 amps. To reduce the risk of fire from overloading an
electrical circuit:
► Ensure the electrical system is rated to withstand the
expected electrical draw before charging your battery.
► Charge multiple batteries one at a time or on separate
circuits, unless you know your circuit can handle the total
expected draw from multiple chargers.
WARNING
Since the battery and charger heat up during the charging
process, do not operate the charger on a combustible
surface or in a location where combustible gases, liquids,
vapors, dusts or other materials are present, @ 5.
To set up the charger:
1
► Insert the plug (3) into a properly installed electrical
outlet (4) matching the voltage and electrical frequency
stated on the charger's rating plate.
The charger runs a self-test immediately after it is plugged
in. The LED (1) will glow green for about 1 second, then it
will glow red briefly before going out. Once the LED goes
out, the self-test is complete and the charger is ready to
charge the battery.
7 CHARGING THE BATTERY
4
3
2
0458-010-8221-A