Led Diagnostics; Led On The Charger; Transporting; Charger - Stihl AL 301 Notice D'emploi

English
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 18 in. (450 mm)
– b = minimum 3.9 in. (100 mm)
– c = 3.9 in. (100 mm)
– d = 0.2 in. (4.5 mm)
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2.5 mm)

8 LED DIAGNOSTICS

8.1

LED on the Charger

One LED shows the status of the charger. The LED can glow
green or flash red.
If the LED glows green continuously: the battery
is being charged.
or
The battery is too hot or too cold for charging. To
determine, check the LEDs on the battery. If
there is one glowing red light, allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If the LED flashes red: there is no electric contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Check the LEDs on the battery. Do not
use or charge a battery if its LEDs indicate a
malfunction.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.
8
For more information, @ 12.

9 TRANSPORTING

9.1

Charger

To properly transport the charger:
► Disconnect the charger from the electrical outlet.
► Remove the battery from the charger.
► Wrap the power supply cord and attach it to the charger.
► When transporting the charger in a vehicle, ensure that it
is secured in a manner that prevents turnover, impact and
damage.
10STORING
10.1 Charger
To properly store the charger:
► Disconnect the charger from the electrical outlet.
► Wrap the power supply cord and attach it to the charger.
► Store the charger indoors in a dry and secure location.
► Keep it out of the reach of children and other unauthorized
persons.
8 LED DIAGNOSTICS
1
0458-010-8221-A