Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
It is recommended to use the cord retainer in the rear handle
to prevent accidental disconnection of the power supply.
10.1
EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add oil if necessary.
10.2
HOLD THE MACHINE
1. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that your left hand holds the front handle and
your thumb is below the handle.
10.3
START THE MACHINE
3
1. Press the lock-out button (3).
2. Press the trigger (4) while you hold the lock-out button.
3. Release the lock-out button.
10.4
STOP THE MACHINE
1. Release the trigger to stop the machine.
NOTE
4
English
10.5
FELL A TREE
25
It is recommended that the first-time user should, as a
minimum practice, start cutting logs on a saw-horse or cradle.
Before you start to fell a tree, make sure that:
•
The minimum distance between the areas of bucking and
felling performed by two or more persons at the same
time is two times the height of the tree felled.
•
The operation does not:
•
Cause injury to personnel.
•
Hit utility lines. If the tree touches utility lines,
immediately tell the utility company.
•
Cause losses in property.
•
The user is not in the danger area (24), for example, the
downhill side of the area.
•
The escape paths (25) that extend back and diagonally
behind the felling direction (23) are clear. The felling
direction is controlled by:
•
The natural lean of the tree.
•
The location of larger branches.
•
The wind direction.
•
Ensure there is no dirt, stones, loose bark, nails, or staples
on the tree.
26
2''(50mm)
29
27
1. Make a lower level notching cut (27). Make sure that
this cut is:
a) 1/3 width of the diameter of the tree.
b) Perpendicular to the felling direction.
10
23
24
25
24
28
2''(50mm)
Publicité
Table des Matières
Dépannage
