Connect The Machine To The Power Supply; Operation - GreenWorks CSA801 Manuel De L'utilisateur

13
2. Remove the chain cover.
3. Put the chain drive links (21) into the bar groove (20).
17
4. Put the chain cutters (22) in the direction of the chain

operation.

21
20
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
18
7. Put the chain loop around the sprocket (17).
11
16
15
22
19
English
8. Make sure the chain tension pin hole (15) on the guide
bar fits correctly with the bolt (16).
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob (13) when the chain is
correctly tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
9.4 CONNECT THE MACHINE TO
THE POWER SUPPLY
The machine has a cord retainer.
6
1. Form a loop at the end of the extension cord.
2. Put the loop portion of extension cord through opening at
the bottom of the rear handle.
3. Place over cord retainer.
4. Pull the loop against cord retainer until the slack is
removed.
5. Plug the machine into the extension cord.
10 OPERATION
Before you plug in, examine if the rated mains voltage and
mains frequency, as tell on the rating label, match your
power supply.
Before operation, examine if the mains connection cable
and extension cable have damage. Only use the mains
connection cables and extension cables in good condition.
Examine the chain tension before each use.
9
NOTE
NOTE
WARNING
WARNING
IMPORTANT
EN