Add The Bar And Chain Oil; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks CSF401 Manuel D'opérateur

Masquer les pouces Voir aussi pour CSF401:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
9.2

ADD THE BAR AND CHAIN OIL

Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain oil as follows.
Use bar and chain oil that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
oil.
1. Loosen and remove the cap (8) from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator (7) to make sure that no dirt gets
into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
9.3

INSTALL THE BATTERY PACK

If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read and understand the instructions in the battery and
charger manual.
IMPORTANT
NOTE
8
7
IMPORTANT
18
15
WARNING
English
1. Align the lift ribs on the battery pack (15) with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
9.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (18).
2. Remove the battery pack from the machine.
10

OPERATION

Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
Examine the chain tension before each use.
10.1

EXAMINE THE CHAIN OIL

Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add the oil if it is necessary.
10.2

HOLD THE MACHINE

1. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that your left hand holds the front handle and
your thumb is below the handle.
8
NOTE
IMPORTANT
NOTE

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

2000600

Table des Matières