S&P RESPIRO 100 Mode D'emploi page 38

PRODUCT RESET
1. Turn on the unit using the "0/1" switch. The red LED lights up.
2. Press the "SUPERVISION MODE" button 5 times. It is important that no time elapses between step 1 and 2, otherwise you
EN
will have to start over.
3. Wait 30 seconds. Verify that the red LED stays on permanently.
4. Turn off the unit with the "0/1" switch and leave it off for about 15 seconds.
5. Turn on the unit with the "0/1" button and do not press any button on the remote control.
6. Wait for the red LED to turn off, then wait for the LED to blink white after a few seconds.
7. Once the white flash is displayed, the unit will restart. Pay attention to the "START UP" paragraph before proceeding.
REPLACEMENT OF REMOTE CONTROL BATTERY
After a long period of use, the remote control's battery may need replacement.
The battery should be replaced when the product no longer responds to the com-
mands sent by the remote control.
The battery model to purchase is CR2025 3V.
As in the image on the right press the lever inwards on the remote control (1), and
extract the battery support by pulling it towards you (2).
After taking out the run-down battery, dispose of it in the appropriate containers
as defined by the regulations in your country. Replace it with a new battery of the
same model, positioning it as in the image on the right.
Re-insert the battery support with the new battery.
MAINTENANCE
All the device's maintenance operations are exclusively aimed at qualified staff.
Make sure that the room's mains network is disconnected before carrying out maintenance operations.
Once installed, the product's components should be arranged as shown in the above image.
38