S&P RESPIRO 100 Mode D'emploi page 42

Les langues disponibles

4) PUTTING THE PRODUCT BACK IN SERVICE AFTER CLEANING

Remount the main unit (3) together with the damper (2) and embellisher cover (1) on the wall attachment (4i).

Attention: If you are cleaning several units at the same time, remount each main unit in the location you removed it from in

order to avoid communication problems between master units and slave units.

4a) RESPIRO 100 / RESPIRO 150

Simply reinstall the main wall unit and power up the product by turning it on with the master switch.

4b) RESPIRO 100 RD / RESPIRO 150 RD

Once you have put the main unit back in its wall housing, turn the product on with the master switch, to reset the cleaning

counter it is necessary to use the remote control (execution of the reset after filter cleaning is included in the remote control

instruction manual).

INSTRUCTIONS FOR CORRECT OPERATION

RESPIRO 100/RESPIRO 150

Speed selection (1/2)

On/off (0/1)

1. Turn-on

Once the product has been installed by qualified staff, turn it on by actuating the "0/1" switch on the side of the main unit.

Make sure that the indicator light is on.

Once the damper is open the product starts working normally with the 70 seconds air intake and 70 seconds air extraction

cycle.

2. Speed selection

It is possible to increase or decrease the air exchange flow by means of the "1/2" switch on the side of the product.

Select speed 1 for a more silent air exchange.

Select speed 2 for a faster air exchange.

3. Wall commands

If during the installation carried out by qualified staff, the "on/off" and "speed selection" controls are remounted on the

wall, make sure that the controls on the product are both positioned at "1".

The instructions for the commands remounted on the wall are the same as those of the aforementioned product.

4. Turn-off

Position the "0/1" switch on the side of the unit to "0".

If the controls have been carried to the wall, position the wall-mounted switch to "0". Keep the "on/off" switch on the side

of the unit on "1".

RESPIRO 100 RD/RESPIRO 150 RD

On/off (0/1)

Respiro 100 rd Respiro 150 Respiro 150 rd