S&P RESPIRO 100 Mode D'emploi page 43

If you only have one unit, access the product using the "0/1" switch and then wait for the correct configuration. After the red
and white configuration pulse, the machine will start in the "AUTOMATIC" function.
If you have more than one unit, see the paragraph "MASTER-SLAVE PRODUCTS CONFIGURATION".
Attention: When first turned on the product executes the auto-calibration of the hygrostat. It is possible that during this
phase the "EXTRACTION" function will be activated to bring the room's humidity below the level required for this auto-ca-
libration.
PROBLEMS ENCOUNTERED
'S&P's official service network provides full technical assistance. If you note any anomaly in the device's operation, please
contact one of the above departments, who will be delighted to help you. Any handling not strictly necessary for the insta-
llation of the device, executed by parties other than official S&P services, will force us to cancel the guarantee.
For any questions about S&P's products, please contact the Assistance Department.
TECHNICAL ASSISTANCE
If the product fails to turn on or it operates abnormally or is abnormally noisy, disconnect the product from the power by
positioning the "0/1" switch on the side of the main unit to "0". Contact your dealer immediately and request technical
assistance from our qualified staff.
REMOVAL FROM SERVICE, DISPOSAL AND RECYCLING
EU regulations and our commitment to future generations oblige us to recycle used materials; please remember to
dispose of all unwanted packaging materials at the appropriate recycling points, and to drop off obsolete equipment
at the nearest waste management point.
S&P reserves the right to modify the product without prior notification.
EN
43