Assembly - Sonnenkonig WINDMASCHINE 18 OSC Notice D'utilisation

3 Assembly

1. Slide the Fan motor over the Base and using the Securing Screw tighten.
2. Remove the 4 screws from the fan motor.
3. Fit the back safety guard into position (with the handle on the back of the guard at the
top) and refit the 4 screws and tighten.
4. Slide the fan blade onto the spindle ensuring the screw is lined up with the "flat"
surface on the spindle. Push on until the end of the spindle is flush with the end of the
fan blade hole, then tighten the screw.
5. Open up all locking clips on the sides of the front guard. Place the safety guard into
position by lining up the location plate over the top of the rear guard and push down.
Secure the guard by closing the clips over the outer rim.
Then using the small nut and screw, fasten the two guard s together.
1
4
2
5
35 35
3
GB