GYS NOMAD POWER VAC 350 Manuel D'utilisation page 11

Translation of the original instructions
"Forced start" button
5
6
8
If the starting fails or the NOMAD POWER fails, see the table below:
LED Indicator
The green/red LED flashes.
The red LED is always on.
The red LED flashes quickly.
The green LED flashes slowly.
USE AS A VACUUM CLEANER
1
2
3
Vacuum cleaner indicators
The vacuum cleaner is in working order.
When the operating condition of the vacuum
cleaner is abnormal, such as when a foreign
object is blocked or when the motor is broken,
etc., the vaccum cleaner will not work properly.
When the power is too low.
NOMAD POWER VAC 350
Press and hold the button (11), located on top of the smart start cable, for 3 seconds to
initiate a forced start.
The light on the starter cable turns steady green. Perform a start up within 30 seconds.
After starting, disconnect the smart start cable (9) from its connector (6) and remove the 2
clamps from the vehicle's battery terminals within 30 seconds.
Leave the vehicle running.
!
After the start-up, if the internal battery is less than 80%, recharge the NOMAD POWER.
Wait at least 30 minutes after starting the vehicle to charge the NOMAD
!
POWER.
Situations
The booster recharges the battery. It is waiting for a start.
1. Reverse polarity - check the connection of the clamps.
2. Short-circuit - check that the two clamps are not connected together or to
the same terminal.
The temperature of the smart start cable exceeds 65 degrees.
Disconnect the battery clamps and the smart cable from the NOMAD POWER.
Voltage is too low - replace the starter power supply or change it.
Open the protective cover of the vacuum cleaner.
Press the ON / OFF button (2).
If necessary, select the appropriate accessory (13 ̶ 14) and vacuum.
The green light (1) is always on.
The red indicator (1) flashes 3 times and then turn off automatically.
To solve this problem, remove foreign bodies and restart the vacuum
cleaner. If the light continues to flash 3 times and goes out automati-
cally, contact us to confirm whether the motor is broken or not.
The red light (1) flashes 3 times and then goes out, it must be
charged before it can be used normally.
EN
11