Connections; Usb Port Connection; Parallel Port Connection - Sony Digital Graphic Printer UP-D895 Mode D'emploi

Connections

After connecting the computer interface cable to the
computer and the printer, connect the power cord. The
interface cable may vary depending on the computer in
use. For details about printer connection, refer to the
manuals for the computer or other peripheral devices.
Notes
• Before connecting the printer to the computer, switch
off the printer, computer, monitor, and all peripheral
devices connected to the computer.
• Before connecting the printer to the computer,
disconnect the power cord from the printer. Connect
the power cord to the printer only after connecting the
printer and the computer.
• To connect the printer and computer, use an interface
cable that matches either the USB or Centronics
parallel connections on the printer.
• Follow the connection procedures described in the
computer manual.
• An interface cable less than 2 meters (about 6 1/2 ft.)
long and protected with ferrite core seals at both
connectors is recommended.
• Make sure that the interface cable is connected
securely at both ends.
• The printer driver software provided with the printer is
not suitable for using the printer connected to a
network.
• Operation of the printer is not guaranteed for
connection to a USB hub.
• If a USB cable and parallel printer cable are
connected at the same time, only the USB
connection is used and the parallel connection
cannot be used.

USB Port Connection

USB DIP SW
OFF
ON
DIP SW FUNCTION TABLE
NO FUNCTION SW-ON SW-OFF
1 TONE
GAMMA AC IN
2 TONE TONE
3 RESIZE TO FIT ON OFF
4 COMMAND D895 D890
5 POST FEED ON OFF
6 RESERVED
7 RESERVED
8 RESERVED
Interface cable

Parallel Port Connection

DIP SW
USB
OFF
ON
DIP SW FUNCTION TABLE
NO FUNCTION SW-ON SW-OFF
1 TONE
GAMMA AC IN
2 TONE TONE
RESIZE TO FIT ON
3 OFF
4 COMMAND D895 D890
5 POST FEED ON OFF
6 RESERVED
7 RESERVED
8 RESERVED
Interface cable
Note
An IEEE STD 1284 interface cable is required in order
to use the printer in the ECP mode, and the computer
must be set to use the local parallel port. For details,
refer to your computer manual.
5
Connections