AL-KO SOLO Robolinho 1100 Mode D'emploi page 58

GB
■
"Change"
setting.
■
"Continue"
setting and continue to the next setting.
3. "Save" : Save all changed settings of
the menu item.
7.4 Edge mowing with a manual start
For a manual start, the setting can be made here
that the appliance begins with edge mowing.
Carrying out the edge mowing at the pro-
grammed mowing time periods: see chapter 7.3.3
"Setting the mowing times", page 57.
1.
*"Margin mowing"
2.
*"at manual start"
7.5 inTOUCH
An existing connection to a gateway can be dis-
connected. This means the appliance is ready to
establish a new connection for 30 minutes.
NOTE
To establish a connection later, the con-
nection must first be disconnected
again, even if the appliance was not pre-
viously connected with a gateway.
1.
*"inTOUCH"
2. "Reset connection"
Appliance reports: "Done".
3. Confirm with
7.6 Setting the secondary area mowing
1.
*"Sub zone mowing"
2. Setting the mowing time periods:
■
"inactive"
ea mowing is switched off.
■
"active"
mows until the rechargeable battery is
flat.
■
"Mowing time in min"
The appliance mows the secondary area
for the set time period. The following
mowing time periods can be set:
30/60/90/120/until rechargeable battery
flat.
58
: Change the selected
: Confirm the changes
and return to the menu.
: Secondary ar-
: The appliance
7.7 Setting the display contrast
If the display is difficult to read, e.g. in sunlight,
the display can be improved by changing the dis-
play contrast.
1.
*"Display contrast"
2. Increase/decrease the display con-
trast.
7.8 Setting lock
If the setting lock is deactivated, the PIN must on-
ly be entered when acknowledging safety-rele-
vant faults.
1.
*"Safety settings"
2. Activating/deactivating the setting lock:
■
"Activate"
Activate the setting lock.
■
"Deactivate"
Deactivate the setting lock.
7.9 Recalibrating
If the position or length of the boundary cable has
been changed or the appliance no longer finds
the boundary cable, recalibration is necessary.
1. "Reset calibration"
2. "Reset loop calibration data?"
3. Carrying out a calibration movement: see
chapter 5.4 "Carrying out an automatic cali-
bration movement", page 55.
7.10 Restoring factory settings
The factory settings of the appliance can be re-
stored, e.g. before selling the appliance.
1.
*"Factory reset"
message: "Factory reset completed"
8 DISPLAYING INFORMATION
The "Information" menu is used for displaying
machine data. No settings can be made in this
menu.
:
1. Call up the main menu.
2.
*"Information"
3. Select the menu item.
Note: The menu items are described in the
following sections.
4. Return to the main menu.
Displaying information
:
:
Robolinho 1100/110