AL-KO SOLO Robolinho 1100 Mode D'emploi page 57

Settings
7.3 Setting the mowing program
7.3.1 Setting the mowing program – General
1. Call up the main menu.
2.
*"Programs"
3. Select the menu item.
4. Make the settings.
Note: The menu items are described in the
following sections.
7.3.2 Setting the start points (only for
Robolinho 1100)
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance.
3. Call up the main menu.
4.
*"Programs"
5.
*"Entry Point"
6.
*"Interactive teach"
7.
*"Start interactive entry
point teaching"
■
"Start"
along the boundary cable.
■
"Set"
reached the required start point. The start
point is stored.
8. "Set entry point 1"
point has been specified during the teaching-
in movement. If no start point has been spec-
ified here, the start points are automatically
specified.
9. "Entry point x: XXm" if the last start
point has been reached.
Manually specifying start points (01)
The first start point (01/X0) is pre-set and is 1 m
to right of the base station. Up to 3 other start
points (X1 to X3) can be programmed behind this
point. When specifying the start points, heed the
following:
■
Do not set start points too far from the base
station or too close to one another (02/f).
■
Only use as many start points as necessary.
1.
*"Entry Point"
2.
*"Point X1 at [020m]"
Select one digit in sequence with
and confirm each time with
457290_b
.
. The appliance moves
when the appliance has
if no start
.
3.
*"Point X2 at [075m]"
Select one digit in sequence with
confirm each time with
4. If necessary, specify further start points.
5. Return to the main menu.
7.3.3 Setting the mowing times
NOTE
There must be at least 30 min. between
programming the mowing times and the
mowing start. If not, the appliance only
starts at the next programmed mowing
time.
In the "Weekly Program" menu item, the days
of the week and time periods when the appliance
should mow are set. Adapt these settings to the
size of your garden if necessary. If unmown ar-
eas are still visible after approx. one week, in-
crease the mowing periods.
1.
*"Weekly Program"
■
mows every day at the set times. If "All
Days [ ]" is shown, the appliance only
mows on the set days of the week.
■
[X]": The appliance mows for the set
time periods on the set day of the week.
If "Monday [ ]" is shown, for example,
the appliance does not mow on the re-
spective day.
■
"Change"
day [X] or deactivate it [ ], and set the
time periods, type of mowing and the
start points.
2. Make the settings for every day or the re-
spective day:
■
For example, *"[M] 07:00-10:00
[?]": Normal mowing [M] from 07:00 –
10:00 am with automatically changing
start point 0 – 9 [?].
■
For example, *"[R] 16:00-18:00
[1]": The appliance starts with edge
mowing [R] at 4 pm and moves along
the entire boundary cable. The area
mowing then begins at start point 1 [1].
At 6 pm or as soon as the rechargeable
battery is discharged, the appliance
to
moves back to the base station.
.
*"All Days [X]": The appliance
*"Monday [X]"...*"Sunday
: Activate the respective
and
57