Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SCAN
Your radio is equipped with the Scan feature,
which allows you to monitor multiple channels/
talkgroups for voice activity. The radio will stop
on a channel/talkgroup when it detects activity
on it.
Scan lists are assigned per channel/talkgroup,
by your dealer/programmer. Your radio
automatically switches to a channel/talkgroup,
within that scan list, when it detects activity.
You can edit these lists through your radio's
menu (see page 35).
•
The LED indicator blinks green during scan
mode; it stops blinking when the radio switches
to an active channel/talkgroup.
•
The Gsymbol appears on the display while in
scan mode.
There are two ways that your radio scans:
•
System Scan (manual)
•
Auto Scan (automatic)
32
English
TALKBACK
The Talkback feature allows you to respond to
a transmission while scanning. If transmission
is detected on a channel/talkgroup while
scanning, the radio will stop on that channel/
talkgroup for a default period of time after
activity has ceased. This is referred to as
"hangtime". During this hangtime you may
respond by pressing the PTT button.
Note:
The LED scan indicator stops blinking while
the radio is in hangtime. If the PTT button is
not pressed after the preprogrammed
hangtime, the radio returns to scanning
channels/talkgroups.
START SYSTEM SCAN G
Press the preprogrammed Scan button to start
scanning channels/talkgroups in your scan list
(if Auto Scan is not enabled) (see page 17).
– or –
1
Select a channel or talkgroup that contains a
Scan list.
J
2
to enter menu mode.
Publicité
Chapitres
Table des Matières
