Reading Ctcss / Dpl Values; Reading Auto-Scan Values; Active Channels; Saving Settings - Motorola RM Série Guide De L'utilisateur

Reading CTCSS / DPL Values

Cycle through the features available for
configuration by short pressing the PTT button
until you hear the current code. The radio
moves to the programming CTCSS/PL codes
mode.
Enter a new code value using the SB1 and SB2
buttons.
The RM Series radios have up to 219 codes
available. For more information, refer to
"Frequency and Code Charts" on page 53.

Reading Auto-Scan Values

After hearing the CTCSS/DPL codes, short
pressing the PTT button moves you to Auto-
Scan mode.
Auto-Scan has only two values:
• Enabled
• Disabled
34
English

Active Channels

While in Auto-Scan mode, short pressing the
PTT button shifts the radio to 'Active Channels'
feature. Modify the amount of channels
available using the SB1 and SB2 buttons.

Saving Settings

Once you are satisfied with the settings, you
can either:
• short press the PTT button to continue
programming,
• long press the PTT button to save and return to
'Idle' Programming Mode, or
• long press the PTT button twice to exit 'Idle'
Programming Mode and return to the normal
radio operation.
Note:
• To exit the programming mode without saving,
turn OFF the radio.
• If you 'roll-over' to the beginning of 'Idle'
Programming Mode, you will hear "Channel
Number" . All changed values will be
automatically saved.