Protective Gas Connection - Amann Girrbach ceramill argotherm 2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5.7

Protective gas connection

▷ Connect the gas regulator/gauge to the protec-
tive-gas cylinder.
▷ At the bottom left of the furnace rear wall,
insert the protective gas hose into the gas con-
nection. The resistance of the seal must be
overcome, in order to ensure tightness against
leaks.
Fig. 18
I N S T A L L A T I O N
▷ Connect the other end of the gas hose to the gas
regulator/gauges of the protective-gas cylin-
der. For this, insert the protective gas hose into
the push-in connection by turning and pushing
in, until the resistance of the seal is overcome.
Fig. 19
▷ Completely open the right-hand valve on the
pressure reducer.
To check the gas hose's tightness against leakage:
▷ Open the gas cylinder and gas regulator/gauge.
▷ Widely pivot/move about the gas hose at the
gas regulator/gauge.
There should not be any hissing noise whatso-
ever.
E N
2.
1.
49

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ceramill argovent

Table des Matières