General Safety Instructions; Suitable Personnel - Amann Girrbach ceramill argotherm 2 Mode D'emploi

G E N E R A L S A F E T Y I N S T R U C T I O N S
2 General Safety Instruc-
tions
E N
When installing, starting-up and operating the
machine, always observe the following safety
instructions:
DANGER:
This product does not comply with the ATEX
Directive.
▷ Do not use in explosive atmospheres!
▷ Do not operate with explosive gases or mix-
tures!
WARNING:
Fire hazard!
▷ In case of unexpected processes in the furnace
(for example, strong smoke development or
odour nuisance), switch the furnace off imme-
diately and allow the furnace to cool down to
room temperature.
CAUTION:
A defective machine can lead to malfunctions!
On detection of damage or a functional defect of
the machine:
▷ Label the machine as defective.
▷ Prevent further operation until the machine
has been repaired.
WARNING:
Operation with power sources, products, con-
sumables, auxiliary aids, etc., which are subject
to the Ordinance on Hazardous Substances or in
any way have an impact on the health of the
operating personnel, is not permitted.
36
NOTE:
▷ Switch the machine off when not in use or
unsupervised for longer periods, e.g., over-
night. This method of saving electrical energy
also benefits the environment.
NOTE:
Increased wear of door gasket, insulation, heat-
ing rods and furnace housing!
▷ Avoid opening the furnace when in hot condi-
tion (above 200 °C)!
3

Suitable Personnel

NOTE:
Starting-up and operation of the machine may
only be carried out by trained specialised per-
sonnel.