Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. PANELS MOUNTING
EN
5.8 Mounting panels to the door
Once all mounting and alignment brackets
have been applied to the panels, you can
begin installing the door.
>
Hook the panel to the fixing devices starting
from the top aligning brackets
[ 6
].
>
At this point, alignment between the panel
and adjacent cabinets can be adjusted using the
alignment brackets
[ 7 ]
and mounting brackets
8
].
6
7
>
Vertical alignment: tighten or loosen the screw
in the brackets to raise or lower the panel
9
>
Depth alignment: working from the inside of
the door, after lifting up the magnetic seal on the
handle side and rotating the plastic covers on
the hinge side, adjust the panel position in the
Z-direction by adjusting the shoulder bolts and
setscrews with the 4mm hex key in conjunction
with each other finally locking each mounting
position in place
[ 10 & 11
].
28
[
Once the front panel has been adjusted,
check that the gasket has been repositioned
correctly to assure the door/drawer are
closing and sealing correctly to avoid
operational errors of the unit.
For models accepting custom overlay panels no
8
handles are included with the product. You are free
to supply and mount your own handles matching
your kitchen's aesthetic or order a Fulgor Milano
handle accessory kit from the dealer. Follow the
handle mounting instructions that are included
with the handles. You may need to countersink
screw heads when attaching handles.
5.9 Mounting panels to the drawer
[ 9
].
Once all brackets and handles have been
applied to the panels, you can begin in-
stalling the bottom drawer.
Operate as follows:
>
Partially tighten the screw to the nut in the ap-
pliance drawer
[ 1
].
1
>
Hook the bottom drawer panel starting from the
10
adjustment bolts on the bottom
2
11
>
It is now possible to align panels to adjacent
cabinets in height using the lower alignment
bolts and brackets,
ning the screws into position as needed. With the
screw slighty tightened, move the panel sideways
manually to align it to the other panels on the unit
or other adjacent structures.
Set the bottom adjustment bolts using the lock
nut against the bottom of the drawer once you
are satisfied with the height alignment.
3
>
Depth alignment: working from the inside of
the drawer, after lifting up the magnetic seal or
rotating the cover plate where necessary, adjust
the panel position in the Z-direction by adjusting
the shoulder bolts and setscrews with the 4mm
hex key in conjunction with each other finally
locking each mounting position in place
[ 2
].
[ 3 ]
tightening or untighte-
[ 4 & 5
].
4
5
EN
29
Publicité
Table des Matières
