Hella 2ZR 959 010 Notice Technique

INSTRUCTION SHEET
2ZR 959 010-5xx
for:
APPLICATION AND
MOUNTING INSTRUCTIONS
83mm ROUND REVERSING LAMP
Multivolt 9-33 Volts
Features
• 24 LED design
• Low power consumption
• Ultra fast response time
• Reverse polarity protected
• Built-in transient spike protection
• Ultra long service life
Lens Marking and Installation Requirements
This Reversing Lamp, identified by lens marking E
with ECE Regulation 23 Category R for Reversing Lamps
• A tolerance of +/-3 degrees applies on all mounting details.
• Lamp mounting surface must be vertical to the ground, and at right angles to the longitudinal axis of the
vehicle.
• One lamp is mandatory on vehicles less than 6000 mm and two lamps are mandatory on vehicles over
6000 mm.
• Lamps must not be mounted less than 250 mm and more than 1200 mm above the ground.
• If one lamp is installed, it must be visible from 45° inboard and 45° outboard, as well as from 15° above
and 5° below the horizontal axis.
• If two lamps are installed, they must be visible from 30° inboard and 45° outboard, as well as from 15°
above and 5° below the horizontal axis.
• Lamp is approved to be mounted only with lens engraving "TOP" located correctly.
Rear View
TOP
9010
HELLA-New Zealand Limited, Auckland, New Zealand
• Fully sealed against dust and water
• Withstands most vibration and mechanical shock
applications
• Manufactured from the latest "high tech" acrylic
with enhanced impact and chemical tolerance
• Flush mount for low profile appearance
11391 and the logo was manufactured to comply
4
Side View
Top View
959 150-59 / 03.20