Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTRUCTION SHEET
2NE 959 821-2xx
for:
APPLICATION AND
MOUNTING INSTRUCTIONS
EuroLED
130mm ROUND REAR FOG LAMP
Multivolt 9-33 Volts
Features:
Single LED design
Ultra long life
Reverse polarity protected
Fully sealed against dust and water
Lens Marking and installation Requirements
This Rear Fog Lamp, identified by lens marking E
ECE Regulation 38 Rear Fog Lamps
•
A tolerance of +/-3 degrees applies on all mounting details.
•
Lamp mounting surface must be vertical to the ground, and at right angles to the longitudinal axis of the vehicle.
•
Lamp must be visible from 10° inboard and outboard, as well as from 5° above and 5° below the horizontal
axis.
•
Lamp is approved to be mounted only with lens engraving "TOP" located correctly.
Rear View
HELLA-New Zealand Limited, Auckland, NZ
Low power consumption
Compensates for voltage drop on long vehicles
Withstands most vibration and mechanical shock applications
Manufactured from the latest "high tech" acrylic with enhanced impact and
chemical tolerance
10208 and the
logo was manufactured to comply with
4
Top View
Side View
959 149-99 / 12.20
Publicité
Manuels Connexes pour Hella 2NE 959 821-2 Serie
Sommaire des Matières pour Hella 2NE 959 821-2 Serie
- Page 1 Lamp must be visible from 10° inboard and outboard, as well as from 5° above and 5° below the horizontal axis. • Lamp is approved to be mounted only with lens engraving "TOP" located correctly. Rear View Top View Side View HELLA-New Zealand Limited, Auckland, NZ 959 149-99 / 12.20...
- Page 2 Congratulations, the product you have selected comes from HELLA - a world leader in LED lighting design. Cable Exit Following the launch of the first LED automotive signal lamps in 1990, HELLA Design and Innovation Wiring Colour Coding continues to set new standards. HELLA innovative solutions have been incorporated into millions of lamps, engineered and tested to the most stringent standards, to suit the most demanding environmental LED modules are polarity conscious.
- Page 3 Ce feu doit être visible sur des secteurs latéraux de 10° ainsi que sur un secteur vertical atteignant 5°de part et d'autre de l'axe horizontal. • La lampe a été conçue et certifiée pour un montage avec l'inscription "TOP" située au sommet de l'unité. Vue arrière Vue du dessus Vue latérale Hella-New Zealand Limited, Auckland, NZ...
- Page 4 à LED. Depuis la mise sur le marché du premier feu de signalisation à LED en 1990, les produits HELLA se sont établis comme des références en termes de conception et d’innovation. Afin de résister aux conditions...