Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.7. Menu/Programming function
By repeatedly pressing
day. Pressing only once shows day one, twice shows day two and so on.
Pressing
for 3 seconds allows you to program the radiator directly:
1. Select the CONFORT temperature setting (20ºC to 30ºC), using
and the temperature will flash.
2. Press
and we can select using
The symbol
and the temperature will flash.
3. After pressing the button
show as SEL1, SEL2, SEL3.... We can go forwards and backwards using the button
. Press
to select the day that we wish to program.
4. Pressing
, takes us to the hour we wish to program. To change the hours use the
, buttons. The hours selected will show as (0h, 1h, 2h,...). By pressing the
we can select hour by hour the mode required: CONFORT, ECO or OFF.
5. To finish the programming press
1.7.1. View programming
By repeatedly pressing
day. Pressing only once shows day one, twice shows day two and so on.
1.8. "Open Window" function
This function is activated when the probe detects a reduction of 4º in respect of the set
temperature during 30 minutes.
On activation the following image will appear on the radiator display for 5 seconds:
When the "Open window" function is activated, the following screen will appear showing that
the anti-frost mode is activated:
This function will be active for 2 hours. If the button
radiator will switch off. Pushing the button
"Open window" function being switched on.
we can see the programming that is saved in the radiator for each
and
once again, the numbers of the week will start flashing and
or leave it for 30 seconds without pressing any buttons.
we can see the programming that is saved in the radiator for each
again will switch on the radiator without the
and
the ECO temperature (15ºC to 19.5ºC).
is pushed during this period the
. The symbol
and
or
button,
21
Publicité
Table des Matières
