1.5. Temperature selection
By pressing
than the one set, the radiator comes on, the
1.6. Manual/Automatic mode
By pressing
When the manual mode is selected, the symbol
automatic mode is selected, the symbol
1.6.1. Manual Mode
This enables to choose between the modes of operation COMFORT, ECO and ANTI-FROST,
changing the temperature as indicated in Section 1.5.
SYMBOL
1.6.2. Automatic mode
This mode activates the programming set on the radiator.
1.7 Menu / Programming function
By repeatedly pressing
each day. Pressing only once shows day one, twice shows day two and so on.
Pressing
1. Select the CONFORT temperature setting (20ºC to 30ºC), using
and the temperature will flash.
2. Press
The symbol and the temperature will flash.
3. After pressing the button
show as SEL1, SEL2, SEL3.... We can go forwards and backwards using the button
and
. Press
4. Pressing
and
the
button, we can select hour by hour the mode required: CONFORT, ECO or OFF.
5. To finish the programming press
buttons.
16
or
we change the temperature. When the room temperature is lower
we change between the Manual and Automatic mode.
MODE
COMFORT
ECO
ANTI-FROST
we can see the programming that is saved in the radiator for
for 3 seconds allows you to program the radiator directly:
and we can select using
once again, the numbers of the week will start flashing and
to select the day that we wish to program.
, takes us to the hour we wish to program. To change the hours use the
buttons. The hours selected will show as (00H, 01H, 02H,...). By pressing
symbol appearing.
appears on the display. When the
appears on the display.
TEMPERATURE RANGE
30º C
19,5º C
8º C
and
the ECO temperature (15ºC to 19.5ºC).
or leave it for 30 seconds without pressing any
20º C
15º C
and
. The symbol