Water Supply Connection; Final Check - LG LDF7810BB Instructions D'installation

I I
N N S S T T A A L L L L A A T T I I O O N N I I N N S S T T R R U U C C T T I I O O N N S S
These installation instructions are intended for use by Qualified lnstallers.
Step 11
1. Before connecting, turn off the
water supply.
2. After fitting the Elbow into the
Inlet Valve, slide the Flexible
Stainless Tube or Copper Tube
into the Elbow.
3. Tighten the nut and make sure
that the line is not kinked or
sharply bent.
Step 12
1. Before beginning, turn off
electrical power to the unit at
the circuit breaker.
2. Remove the Junction Cover
and then Install the Strain
Relief.
3. Twist Wire Connectors tightly
on the wires. Wrap each
connection with Electrical tape.
4. Check again and make sure
that all wires are connected
correctly, black to black, white
to white, green to green
(ground to ground).
5. Replace the Junction Cover.
Step 13
1. Turn electrical power back on at the circuit breaker.
2. Turn house water supply back on.
3. Operate the dishwasher through one cycle (Quick cycle is recommended) to check for water
leaks and operating conditions.
4. Replace the Lower Cover.

WATER SUPPLY CONNECTION

Water Supply Tube
ELECTRICAL POWER CONNECTION
Junction Cover
Wire Connector
Junction Case
Strain Relief

FINAL CHECK

Inlet Valve
Elbow
black to black
green to green
(ground to ground)
white to white
11