LG LDF7810BB Instructions D'installation page 6

I I
N N S S T T A A L L L L A A T T I I O O N N I I N N S S T T R R U U C C T T I I O O N N S S
These installation instructions are intended for use by Qualified lnstallers.
Step 1
1. This dishwasher is designed to fit a standard dishwasher opening as shown below.
2. Select a location as close to sink as possible for easy connections to water and drain lines.
3. The dishwasher should not be installed more than 10 ft. (3m) from the sink for proper
drainage.
4. If dishwasher is to be installed in a corner, a minimum of 2 in. (50mm) is required between
the dishwasher and an adjacent a wall.
5. To allow for proper clearance of plumbing and electrical measure a 4" x4" target area (figure
#1) on the side of the cabinet where the cabinet meets the back wall. Using a 2 1/2"
diameter hole saw drill a hole (in the target area) within 4" from the floor, and no more than
an 1 5/8" from the back wall. If there is a floor in the cabinet under the sink, it will also be
necessary to drill or cut through the floor to connect the water and drain under the sink.
NOTE Failure to cut this opening will result in the drain hose interfering with the rear wall not allowing
for flush mount installation.
figure #1
Must have this opening (on either
side) to route plumbing and
electrical.
■ Ensure the floor under the dishwasher is at the same level as the rest of the room to
allow for any service requirements.
PREPARE CUPBOARD OPENING
figure #2
For FLUSH INSTALL, you may
remove the Cabinet brace inside of
the cabinet carefully.
5