Emerson Appleton Industrial Mercmaster Connect Instructions D'installation page 8

Pendant Cone (kPCh-75, kPCh-100)
Dimensions:
Mounting Hoods
Pendant (KPA-75, KPA-100, KPAF-75, KPAF-100)
Mounting:
1. Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit stem. thread the pendant hood onto
the 3/4 inch or 1 inch conduit stem.
2. tighten the set screw inside the hood.
JCT BOX
SET SCREW
(INSIDE HOOD)
Pendant Cone (KPCH-75, KPCH-100)
Installation:
Mounting:
1. Apply a corrosion-inhibiting grease, such as petroleum or soap-thickened mineral oils, in 3 lines, spaced approximately
120 degrees apart, perpendicular to the threads on the conduit stem.
1. Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit stem. thread the pendant cone hood
2. Thread the pendant cone hood onto the 3/4 inch or 1 inch conduit stem.
onto the 3/4 inch or 1 inch conduit stem.
3. Tighten the set screw.
2. tighten the set screw.
SET SCREW
Ceiling (KPC-75, KPC-100)
Mounting:
Appleton • 1.800.621.1506 • www.appletonelec.com
1. Bolt the ceiling hood directly to a structural member; thread onto a 3/4 inch or 1 inch conduit stem; or bolt to a flush mounted
LUMINAIRE WITh SMALL hEAT SINk
CEILING
CONDUIT
STEM
PENDANT HOOD
LUMINAIRE WITh LARGE hEAT SINk
fIGURE 7: LUMINAIRE WITh PENDANT CONE hOOD
CONDUIT STEM
fIGURE 8: PENDANT CONE hOOD DETAILS
DOC000083A000 Rev. 03 MY8278 10-MAY-22– Page 8 of 65