Emerson Appleton Industrial Mercmaster Connect Instructions D'installation page 13

90° Stanchion (kPST-125, kPST-150)
Dimensions:
Installation:
1. Apply a corrosion-inhibiting grease, such as petroleum or soap-thickened mineral oils, in 3 lines, spaced approximately
120 degrees apart, perpendicular to the threads on the conduit stem.
2. Thread the stanchion hood onto the 1-1/4 inch or 1-1/2 inch conduit stem. NOTE: Five full threads must be engaged.
3. Determine the appropriate orientation and tighten the set screw.
Appleton • 1.800.621.1506 • www.appletonelec.com
Wall (KPWB-75, KPWB-100)
Mounting:
1. Bolt the wall hood to a structural member.
2. Remove unused conduit plugs and reinstall with tlc-3 grease applied in approximately three
the conduit plugs.
CONDUIT ENTRY (5x)
LUMINAIRE WITh SMALL hEAT SINk
25° Stanchion (KPS-125, KPS-150)
Mounting:
1. Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit s
the 1-1/4 inch or 1-1/2 inch conduit stem. NOTE: five full threads must be engaged.
2. determine the orientation and tighten the set screw.
LUMINAIRE WITh LARGE hEAT SINk
SET SCREW
fIGURE 17: LUMINAIRE WITh 90° STANChION hOOD
90° Stanchion (KPST-125, KPST-150)
Mounting:
1. Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit s
the 1-1/4 inch or 1-1/2 inch conduit stem. NOTE: five full threads must be engaged.
2. determine the orientation and tighten the set screw.
SET SCREW
fIGURE 18: 90° STANChION hOOD DETAILS
DOC000083A000 Rev. 03 MY8278 10-MAY-22– Page 13 of 65