Mounting The Multifunctional Module In The Ball Valve - GF 546 Manuel D'utilisation

Instruction manual

3 Mounting the Multifunctional Module in the Ball Valve

Immediately prior to installation, inspect the MF module for transport damages. We
recommend leaving the MF module in its original packaging until you are ready to install it.
The MF module has been fitted ex works with the respective switches and function-tested! It
is not necessary to remove the cover when used with the hand-operated ball valve.
Design of the MF module with built in switches
1 Housing
Housing cover
2
Switching disc*
3
*) for MF module versions with pre-assembled Micro Switches
The MF module can be mounted on the ball valve type 546 in the opened or closed ball
position.
 ATTENTION! The stem is asymmetrical.
 The stem position must be identical to one of the two illustrations.
Mounting the Multifunctional Module in the Ball Valve
3a Switching cam
Stainless steel Torx screws
4
Connector plug 3P + E per DIN
5
EN ¢75301-803 (formerly DIN 43650)
7