Abbreviations; Ce Marking; Other Related Documents; Intended Use - GF 546 Manuel D'utilisation

About this document

1.3 Abbreviations

Abbreviation Meaning
Type 546 Ball Valve Type 546
MF handle Lockable multifunctional handle
MF module Multifunctional module
PN Nominal pressure

1.4 CE Marking

According to EC Directive 2014/68/EC pertaining to pressure equipment, complete valves M
DN 25–DN 50 are CE-certified.
Single components, spare parts and complete valves M DN 08–DN 20 may not be CE
marked. Single components and spare parts must be tested by the customer
himself following completion.

1.5 Other related documents

•
Georg Fischer planning fundamentals industry
These documents can be obtained via the agency of GF Piping Systems or under
www.gfps.com.

1.6 Intended Use

When mounted on the Ball Valve Type 546, the Multifunctional Module serves:
 to signal the CLOSED or OPEN position of the valve via an electric signal to a control
supplied by the customer
 as a support for back wall installation of the manual ball valve
 as an interface when mounting an electric or pneumatic actuator
It is important that the given electrical data, such as voltage and current load, are
strictly observed.
The MF module is not intended for uses other than those stated here. If the
instructions contained in this manual are not complied with, the manufacturer is
excluded from all liability for the above mentioned product.
4
WARNING
Instruction manual