Hilti PLT 300 Mode D'emploi page 26

7.2 Storage
ATTENTION
Risk of damage Leaking batteries may damage the product.
▶ Remove the battery if the tool is to remain unused for a long period of time.
▶ Do not put the tool into storage when wet. Allow it to dry before putting it away.
▶ Always clean the tool, its transport container and accessories before putting them into storage.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
▶ Observe the temperature limits when storing the equipment, especially in winter and summer (-40 °C to
+63 °C (-40 °F to +145 °F)).
8 Disposal
WARNING
Health hazards Never dispose of the equipment carelessly or improperly!
▶ The burning of plastic components generates toxic fumes which may present a health hazard. Batteries
may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution.
▶ Careless disposal may permit unauthorized and improper use of the equipment. This may result in
serious personal injury, injury to third parties and pollution of the environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or
incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance with the official
regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 FCC statement (applicable in US) / IC statement (applicable in Canada)
CAUTION
Interference to radio reception Use of the product in residential areas may cause interference to radio
reception.
▶ This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause interference to radio communications. Operation of this equipment
in a residential area is likely to cause interference. In this case, users will be required to remedy the
interference at their own expense.
Changes or modifications not expressly approved by Hilti may restrict the user's authorization to operate
the equipment.
This device is in compliance with paragraph 15 of the FCC Regulations RSS­210 of the IC Regulations.
Operation is subject to the following two conditions:
This device shall cause no harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
20 English 2100874
*2100874*