Hilti PLT 300 Mode D'emploi page 22

3.1.2 PLC 300 2
3.2 Intended use
The product described consists of the cordless PLT 300 layout tool and the PLC 300 cordless controller.
The PLC 300 allows remote control of the PLT 300. Both components form a system. The layout tool is
designed to be used for measuring distances and directions, calculating target positions in three dimensions
and laying out given coordinates or values relative to a control line.
▶ Use only Hilti lithium­ion batteries of the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C 4/36 series to charge these batteries.
3.3 Wi-Fi antennas 3
A Wi-Fi antenna is located at each narrow side of the controller.
▶ When operating the controller, don't hold it at the sides where the Wi-Fi antennas are located as this
reduces its transmitting and receiving performance.
A holder for the controller, which helps avoid degradation of Wi-Fi performance, is available as an
accessory.
3.4 Data link to periphery devices
The software Hilti PROFIS Layout Field is used on the PLC 300. The PC software Hilti PROFIS Layout Office,
for processing and transferring data to other systems, is also available for use on PCs. Data can be
exchanged between these two software products.
Data from the PLC 300 can be transferred directly to USB data media.
3.5 Items supplied
PLT 300, PLC 300, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com.
16 English
Key
Microphone
@
Ambient light sensor
;
Front camera
=
Front camera status indicator
%
Volume control
&
On/off button
(
Display rotation lock button
)
System control button
+
Operating status indicator
§
Data storage status indicator
/
Battery status indicator
:
Wi-Fi antennas
∙
Earphone socket
$
USB connector
£
Docking connector
|
Charging socket
¡
Rear camera
Q
Rear camera status indicator
W
Battery compartment
E
Battery compartment catch
R
microSD card slot
T
2100874
*2100874*