Télécharger Imprimer la page

Murray 425307x51A Manuel De L'opérateur page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
Assembly
All fasteners are in the parts bag. Do not discard any
parts or material until the unit is assembled.
WARNING
Before doing any assembly or maintenance to the
mower, remove the wire from the spark plug.
NOTE: In this instruction book, left and right describe
the location of a part with the operator on the seat.
Install the Front Wheels
Use a knife and cut the four sides of the container. Install
the front wheels (1) in the container (see Figure 1).
NOTE: Use a piece of wood about 4 feet (1.25 meters)
long to raise the front of the tractor. If a piece of wood
cannot be found, get another person to help lift the
tractor. Be careful, do not let the tractor fall.
7
(17x195)
4
5
(30x49)
6
2
(17x192)
3
1
Figure 1
1. Raise the front of the tractor. Set a support (block of
wood) under the tractor.
2. Make sure the valve stem (2) is to the outside of the
tractor. Slide the front wheel (1) on the spindle (3).
3. Fasten each front wheel with washer (4), washer (7)
and cotter pin (5). Bend the ends of the cotter pin
apart to keep the front wheel on the spindle.
4. After the front wheels are installed, lift the tractor from
the support. Roll the tractor off of the container.
5. If your tractor has hub caps (6), install the hub caps.
Make sure the washers hold the hub caps in place.
Check the Tires
Check the air pressure in the tires. Tires with too much air
pressure will cause the unit to ride rough. Also, the wrong
air pressure will keep the mower housing from cutting
level. The correct air pressure is: Front Tires 0,97 BAR
(14 PSI), Rear Tires 0,69 BAR (10 PSI). The tires were
over inflated for shipment.
en
9

Publicité

loading

Ce manuel est également adapté pour:

7800282