Murray 425307x51A Manuel De L'opérateur page 28

Maintenance
Remove the Transaxle Drive Belt
1. Remove the battery.
2. Remove the mower housing. See "Remove and
Install the Mower Housing."
3. Remove the variator brake arm (23) at the top of
the frame channel (see Figure 29). The variator
brake arm can be accessed through the
battery box opening under the seat.
5
25
24
4. Remove the variator idler spring (24).
5. Remove the two screws (25) on the right side of
the variator assembly bracket (5).
6. Loosen the two screws (26) on the left side of the
variator assembly bracket.
7. Remove the shifter rod from the transaxle shifter
link (27) (see Figure 30).
28
8. Remove the transaxle drive belt (28) from the
26
9. Slip the transaxle drive belt off of the variator idler
23
10. Slide the transaxle drive belt forward over the
11. Next, slide the transaxle drive belt over the transaxle
Figure 29
12. Pull down on the variator assembly (30) and
13. A correct replacement belt and/or assistance is
27
Figure 30
transaxle input pulley (29) (see Figure 31).
15
10
30
29
28
pulley.
transaxle input pulley.
shifter link (27) (see Figure 30).
remove the engine drive belt (10) from the variator
pulley (15). Then, remove the transaxle drive belt (28)
from the variator pulley (see Figure 31).
available from an authorized service center in your
area.
en
Figure 31