PRO-POINT 8354649 Mode D'emploi page 12

V 3.05
AIR TOOL LUBRICATION
Only use air tool oil to lubricate the tool. Other lubricants may
not be suitable and could damage the tool or cause a malfunction
during use.
1. All air tools are packed in grease to prevent corrosion of
internal parts during shipping and storage. To clean this out,
add a generous amount of air tool oil in the air inlet and then
run the tool under no load until exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool's
male connector before each use and after every hour of
continuous use. Without lubrication, the tool will not work
properly and parts will wear prematurely.
3. Avoid adding too much air tool oil as this can cause
premature power loss and eventual tool failure. The tool will
need to be taken apart by a qualified technician and cleaned
of excess oil.
4. In the event that it becomes necessary to store the tool for
an extended period of time (overnight, weekend, etc.), it
should receive a generous amount of lubrication at that time.
The tool should be run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
12
All manuals and user guides at all-guides.com
5 in. Composite Air Angle Grinder
For technical questions call 1-800-665-8685
8354649