Pre-Operation Checks - Power Fist 8291098 Mode D'emploi

V4.0
A Spark Plug
B Muffler
C Primer
D Safety Key
E Oil Fill Cap
F Fuel Tank and Cap
ASSEMBLY
The engine comes pre-assembled. The engine comes with both a 12V power supply cord and a kill switch cable. A
wiring diagram is found in Appendix A.
WARNING! All wiring should be performed by a qualified electrician.
12V POWER SUPPLY CORD
The engine has a 12 Volt/20 Watt power supply cord for a
work light or similar accessory (Fig. 2). Do not attach any
device to this cord that draws more than 60 watts of power.
The power supply cord has a two-prong male connector for
an easy connection to accessories.
KILL SWITCH CABLE
The engine has a kill switch cable installed (Fig. 3). When
attached to a kill switch on the snow blower or equipment,
this will ground the engine and prevent it from operating until the kill switch is turned off or the safety handle is
held down during operation to complete the electrical circuit.
OPERATION
NOTICE! The manufacturer of the equipment on which this engine is installed specifies the top speed at which the
engine will be operated. Do not exceed this speed.

PRE-OPERATION CHECKS

NOTICE! The engine is not shipped with oil. Before starting the engine, add oil according to the instructions in this
manual. Starting the engine without oil will damage the engine beyond repair.
Check the engine's condition before operating to maximize the user's safety and the service life of the engine.
Ensure that the engine is level and the switch is in the OFF position before beginning the pre-operation checks.
GENERAL CONDITION
1. Look around and underneath the engine for signs of oil or gasoline leaks.
2. Remove any excessive dirt or debris, especially around the muffler and recoil starter.
3. Look for signs of damage.
4. Check that all shields and covers are in place.
5. Check that all nuts, bolts and screws are tight.
CHECK THE ENGINE
1. Check the fuel level. This will save time for refuelling later.
2. Check the engine oil level. Running the engine with a low oil level can cause engine damage (see How to
Check/Add Oil).
3. Check the air filter. A dirty air filter will reduce engine performance.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
208cc OHV Winter Gas Engine
G Starting Handle
H Finger Guard
I Oil Drain Plug
J Choke
K Snow Hood
L Power Cord Receptacle
M Push Button
Electric Start
N Dipstick / Oil Fill
O Engine Identification
(Model – Type – Code)
fig. 2
8291098
fig. 3
5