Automatic Defrost - Oceanic OL-BKY20-A010B2 Guide D'utilisation

C. Drying your room
Press MODE button on the control panel or remote control, the LED of
DRY operation lights up. The fan speed is unable to select. User should
connect the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot
be selected.
D. Sleep mode（this function can only be used with a remote
control）
The sleep mode can be activated when in cool mode
In cool mode :
◼
After 1 hour the preset temperature is increased by 1 ℃, after another
hour the preset temperature will again be increased by 1 ℃.
5.3.3 TIMER SETTING （1hour-24hours）:
The timer has two ways of operation:
To turn off
(When power on)
To turn on
(When power off)
Cancel timer

5.3.4 Automatic Defrost

At low room temperatures, frost may buildup at the evaporator during operation.
The unit will automatically start defrosting and the POWER LED blinking. The
defrost control sequence is as follows:
A. When the unit operates in the cooling operation, drying operation, the
ambient temperature sensor senses the evaporator cold temperature is below
Press Timer key to
turn on the timer
function.
Press Timer key to
turn on the timer
function.
Press UP/Down repeatedly until the LED shows '00'.
Note: when press POWER
setting.
Press Up/Down
repeatedly to adjust the
operating time.
Press Up/Down
repeatedly to set the
delay ON time.
will also exit the timer
62