General Instructions - Boston Scientific Precision SC-5212 Mode D'emploi

Precision® Remote Control
Pay close attention to all battery messages.
Battery Replacement:
NOTE:
• Following a battery replacement, the
Remote Control will reload information
from the implanted or external Stimulator.
• The Remote Control must be within
communication range (two feet) of the
Stimulator during this period.
• It will take about 30 seconds for the
Remote Control to reconnect with the
Stimulator.
Battery removal is recommended if the
Remote Control is not going to be used for an
extended period of time.
1. On the rear of the Remote Control,
push in slightly and slide the battery
compartment cover down.
2. Remove the old batteries.
3. Place the new batteries in the slots by
matching the positive (+) and negative (–)
battery ends with the + / – markings in the
compartment.
4. Align the cover on the case and slide the
cover into position until it snaps closed.
Precision Remote Control
9055929-005 REV A Page 4 of 74

General Instructions

1. To turn stimulation on or off, press the
button.
NOTE:
• When it has not been used for
approximately one minute, the Remote
Control sets itself in a sleep/idle mode
and the display screen is blank. At this
time, the keys become locked. When you
press any button except the
Remote Control will display the following
message:
!
! button, the