Evinrude & Johnson 587280 Manuel D'instructions page 7

Secure connectors in brackets as shown.
2
1
1. Key switch connector
2. Trim/tilt connector
Seal unused engine harness SystemCheck
connector with 6-Pin Connector Seal included in
kit.
Route the CANbus harness from the ESM
around the flywheel cover to the EMM as shown
and secure with tie straps.
1. CANbus harness
1
1. CANbus harness
Continue harness routing to the EMM connector.
Make sure harness is not strained.
008240
1. EMM CANbus connector
Route ESM harnesses as shown and secure
with tie straps. ESM to boat network cable should
go behind and to the port side of the other
cables.
1
1. Network cable
008241
1
1. Network cable
Remove rear solenoid mounting screw and
008242
replace with double-ended screw, lockwasher,
1
008243
1
008244
1
008245
7 of 14